Peel the cut jacket off the bare wire and remove the cable stripper. This will expose the bare wire so you can attach the banana plug. Once you have stripped both cables, you will be able to attach the banana plugs. You will no longer need the wire stripper. Place one of the sets of wire between your finger and thumb, then slide your finger across the top to cause the wires to twist around each other.
Each pair of cables will use a red striped banana plug and a black striped banana plug. The banana plug with the red stripe will attach to the grey cable with the red stripe printed on it. The other banana plug will attach to the black cable. Take the banana plug with the red stripe and unscrew the bottom about half way and feed the speaker wire into the bottom of the banana plug. There is a cone at the front of the plug that spreads the wires in the speaker cable out to ensure a good connection.
This will twist the wire farther into the plug, giving a strong connection. If you have properly fed enough wire into the banana plug, this should tighten down on the wire and keep it from falling out.
Repeat this process for the other banana plug, making sure to insert the cable in as far as you can to ensure a strong connection. With both speaker cables inserted and secured in the banana plugs, simply connect the plugs into the back of your speaker or receiver. Shop Banana Plugs. Some older stereo receivers use a phono style RCA jack just like those used to connect low-level signals.
However, these are different in that they only use the same type of jack by coincidence — the signal is very different. RCA speaker cables do not carry a weak audio signal as RCA audio cable interconnects do, so they need thicker wire. Alternatively, to avoid any hassle with bare wire ends you can use a pin connector set instead. These are affordable and attach to the bare ends, providing a solid pin to insert easily. They also are less prone to slip out.
For car speakers, the tabs are most often a. Of the 4 shown,. How to connect speaker wire to car or home speakers using crimp terminals quick disconnects :. Subwoofers usually have two types of speaker wire terminals: spring-loaded binding posts or quick disconnect slide connector tabs. Spring-loaded terminals are easy to use, while quick-disconnect tabs can be a bit trickier. The terminals are basically rectangular and are often two. For smaller speakers, one may have.
These connectors are harder to find but a. Note that binding posts allow connecting a thicker wire to your amplifier for better power handling. When done properly, crimp terminals should not be able to move and the wire should be nice and tight with no looseness to come apart over time. Standard speaker wire has become brittle and not working well for my outside speakers so I got 16 gauge outdoor wire but it has 4 wires.
Speakers and receiver only us 2 wires. Do I use only 2 of the 4 new speaker wires for my speakers or combine them? Select personalised ads. Apply market research to generate audience insights. Measure content performance. Develop and improve products. List of Partners vendors. By Stanley Goodner Stanley Goodner. Stanley Goodner is a former Lifewire writer who writes about audio equipment, music management, computer hardware, and other consumer technologies.
Tweet Share Email. What to Know Determine whether the speaker wires use banana plugs, spade connectors, or pin connectors. Install a new connector using the self-crimping, open screw, or screw locking method, as appropriate. Was this page helpful? Thanks for letting us know! Email Address Sign up There was an error. Please try again. You're in! Thanks for signing up. There was an error. Tell us why!
0コメント